We use cookies to ensure that we give you the best experience on our website. If you continue without changing your settings, we´ll assume that you are happy to receive all cookies on our Schlüter Website. However, if you would like to, you can change your cookie settings at any time. Further information



Accessories for wiring

We also offer a complete range of accessories for the wiring installation of the Schlüter-LIPROTEC system. Schlüter-KERDI-BOARD installation modules with pre-milled cable ducts are an ideal practical solution. They can accommodate the two-part cable duct Schlüter-LIPROTEC-ZKK; cables are simply inserted from the front. There is no need to thread any wires through conduits. The closed cable duct can then be sealed with the seaming tape Schlüter-KERDI-KEBA and Schlüter-KERDI-COLL-L sealing adhesive.


Schlüter-LIPROTEC-ZK are colour-coded low voltage cables for connecting Schlüter-LIPROTEC LED strips to a suitable power supply unit and/or receiver.

Available dimensions:
2 x 1.31 mm² (AWG)
5 x 1.31 mm² (AWG)

Available length:
25 m


Schlüter-LIPROTEC-ZS are 2-core or 5-core connecting sets for connecting Schlüter-LIPROTEC installations to a suitable power supply unit and/or receiver.

Available core count:


Schlüter-LIPROTEC-ZZK is a supply cable for connecting Schlüter-LIPROTEC-PB staircase systems to the voltage supply.

Available dimension:
2 x 0.32 mm² (AWG22)

Available length:
5 m


Schlüter-LIPROTEC-ZLR is a conduit for preparing subsequent cable installations.

Available diameter:
20 mm

Available length:
50 m


Schlüter-LIPROTEC-ZKK is a cable duct in white colour.

Available length:
2.5 m


Schlüter-LIPROTEC-Z are hollow wall or concealed junction boxes with cover.

Hollow wall junction box
Diameter: 68 mm
Height: 47 mm

Concealed junction box
Diameter: 65 mm
Height: 46 mm

Concealed junction box with cover
Dimensions (L X W X H): 87 x 87 x 60 mm


Schlüter-LIPROTEC-ZKL are 3-core or 5-core connectors

Available core count:


Schlüter-KERDI-BOARD-K are installation modules with pre-milled grooves for accommodating Schlüter-LIPROTEC cable ducts. The groove is designed to also accommodate a 19 mm-thick Schlüter-KERDI-BOARD panel or the Schlüter-LIPROTEC-LL support profile.

Available exterior dimension:
15 x 250 cm

Available heights:
19 mm
28 mm


Schlüter-DESIGNBASE-HVL is a self-adhesive bonding fleece.

Available widths:
38 mm
75 mm

Available length:
20 m


Schlüter-LIPROTEC-RKB is a self-adhesive reflector tape.

Available width:
38 mm

Available length:
50 m


Schlüter-PROCUT-PSF is a special cutting tool for precisely cutting LED tubes to size. To maintain IP-compliant waterproofing when cutting the LED strip, the LED tube must be cut at a 45° angle and closed with the supplied end cap and sealing adhesive.

Illustrated pricelist LIPROTEC 2019
Additional information

LIPROTEC brochure

Brochure as PDF